Use and Care Manual

INSTALLATION

Installation Items Needed (Not Provided)

Regulator

Fig. 11 - Attaching Flexible Gas Line

to Equipment Shutoff Valve

Flexible Gas Line

or Black Pipe to

Fireplace Cabinet

Regulator

To Regulator

• 8'' Adjustable Wrench

• 8'' Pipe Wrench

• Flexible Gas Line (24'' Min.) or 1/2'' Black Pipe

• 90 Deg. 3/8 NPT x 3/8'' Flare Fitting or 3/8'' Street Elbow

• Sealant (Resistant to Propane (LP) Gas)

• Shut Off Valve

1) A variety of options are possible for routing the Gas Connection Lines depending on where

your Gas Supply line is located. Install the 3/8'' Fitting to the Fireplace Cabinet Regulator

using Sealant and direct the attachment and either left or right toward the Gas Supply Line.

2) Install the Gas Line to the 90 Deg. tting and attach to the Shut Off Valve. It may be

necessary to cut and access hole in the side or bottom of the Mantel Cabinet depending on

your particular connection.

3) Check all connections for gas leaks.

NOTICE: Most building codes do not permit concealed gas connections. Check

your local building code prior to using a Flexible Gas Line for this installation.

CAUTION: Use pipe joint sealant that is resistant to gas (PROPANE or NG). We

recommend that you install a sediment trap in a supply line as shown in Fig. 10.

Locate sediment trap where it is within reach for cleaning and not likely to freeze.

Install in the piping system between fuel supply and heater. A sediment trap traps

moisture and contaminants. This keeps them from going into heater controls. If

sediment trap is not installed or is installed incorrectly, heater may not run properly.

CAUTION: Avoid damage to regulator. Hold gas regulator with wrench when

connecting into gas piping and/or ttings. NG Models: 5 in. to 10.5 in. W.C. Gas

supplier provides external regulator for natural gas.