Use And Care Manual

INSTALLATION

BEFORE INSTALLING THE APPLIANCE

- Turn o gas supply to replace or rebox.

- Clean replace oor and chimney before installing log set. Seal any ash. Clean out doors to protect

the unit from down drafts.

MOUNTING ASSEMBLY PROCEDURE

- Place grate/burner assembly into rebox with the front pan facing forward.

- Drill two (2) 5/32" diameter holes approximately 1" deep.

- Anchor the front pan to the oor using the (2) Concrete Attachment Screws (Not Included).

(See Fig. 18).

- Proper installation of the grate is essential to prevent any movement of the gas logs and

controls during operation.

Fig. 18

Mark Location using Log Set Base as Template

and drill a hole in floor of Fireplace 1" deep to

accept concrete screw. (Both Sides)

1/2 x 3/4 Hex Head

Concrete Screw