Use and Care Manual

LIGHTING INSTRUCTIONS

1. STOP! Read the safety information above.

2. Turn control knob clockwise to the “OFF” position (See Fig. 25).

3. Wait ve (5) minutes to clear out any gas. Then smell for gas, including

near the oor. If you smell gas, STOP! Follow “B” in the safety informa-

tion above. If you don’t smell gas, go to the next step.

4. Turn control knob counterclockwise to the “PILOT” position.

Depress control knob.

5. With control knob depressed, push down on the ignitor button until the

pilot lights. The pilot is located behind the heater screen near the rear of

the burner.

• Do not attempt to light the pilot by hand.

6. Keep control knob depressed for (30) seconds after pilot lights. Release

control knob.

• If the control knob does not pop up when released, stop and immediately

call a qualied service technician or gas supplier.

• If pilot goes out repeat steps 3 through 7. Wait (1) minute before attempt-

ing to light pilot again. If after several tries the pilot still goes out, turn the

gas control knob clockwise to the “OFF” position and call a qualied

service technician.

7. Turn control knob counterclockwise to desired setting.

Fig. 25 - Control Knob

Fig. 26 - Pilot

OPERATION

TO TURN OFF GAS TO APPLIANCE

1. Turn control knob clockwise to the “OFF” position.

Shutting O Burner Only (pilot stays lit )

Turn control knob clockwise to the PILOT position.

THERMOSTATIC CONTROL OPERATION

The thermostatic control valve used on this model diers from standard thermostats. Standard ther-

mostats simply turn the burner on and o. The thermostat sensing bulb on the control valve used on

this heater senses changes in room temperature and will vary the ame accordingly. When the room

temperature exceeds the set temperature the burner will shut o completely. The unit will cycle back

on as the room temperature drops below the set temperature. The control knob can be set to the de-

sired comfort level between 1 and 5.

WARNING: Any glass doors shall be completely opened while appliance is in operation.

WARNING: The replace screen must be in place while the appliance is in operation.

LP PILOT

NG PILOT