Installation Guide
21
ASSEMBLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and peridically thereafter, check to ensure that no yellow ame comes in
contact with any log. With the heater set to High, check to see if yellow ames contact any log. If so,
reposition logs according to the log installation instructions in this manual. Yellow ames contacting
logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs; use only logs
supplied with heater. Each log is marked with a
number, and this number will help you identify
each log during installation.
Provided Logs: 6
1. Insert log #1 onto pins in
rear grate base.
2. Insert log #2 onto pins in
middle grate base.
3. Place log #3 onto the
front grate. Make sure the
recessed areas on the log
match up with the grate,
and the log is centered on
grate.
Fig. 22 - Installing Log #4 Fig. 23 - Installing Log #5 Fig. 24 - Installing Log #6
4. Place log #4 so its pin
ts into the hole on the
top left recessed areas of
log #2.
5. Place log #5 so it is resting
in the top middle recessed
areas of log #1 and its pin ts
in the hole on the top of log #2
only (it should NOT be touching
log #3), and the front edge
does no over hang log #2.
6. Place log #6 so its pin
ts in the hole on the top
right recessed areas of
log #2.
1 2 3 4 5 6
VFL2-SO18DT / VFL2-EO18DT / VFL2-SO24DT / VFL2-EO24DT
Fig. 19 - Installing Log #1 Fig. 20 - Installing Log #2 Fig. 21 - Installing Log #3