Installation Guide
22
ASSEMBLING LOGS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and peridically thereafter, check to ensure that no yellow ame comes in
contact with any log. With the heater set to High, check to see if yellow ames contact any log. If so,
reposition logs according to the log installation instructions in this manual. Yellow ames contacting
logs will create soot.
It is very important to install the logs exactly
as instructed. Do not modify logs; use only logs
supplied with heater. Each log is marked with a
number, and this number will help you identify
each log during installation.
Provided Logs: 7
1. Insert log #1 onto pins in
rear grate base.
2. Insert log #2 onto pins in
middle grate base.
3. Place log #3 & log #4 onto
the front grate. Make sure the
recessed areas on the logs
match up with the grate, and the
logs are centered on grate.
Fig. 22 - Installing Log #5 Fig. 23 - Installing Log #6 Fig. 24 - Installing Log #7
4. Place log #5 so its pin
ts into the hole on the
top left recessed areas
of log #2.
5. Place log #6 so it is
resting in the top middle
recessed areas of log #1
and its pin ts in the hole
on the top of log #2.
6.Place log #7 so its pin
ts in the hole on the top
right recessed areas of
log #2.
1
VFL2-WW18DT / VFL2-WW24DT
1 2 3 5 6 74
Fig. 19 - Installing Log #1 Fig. 20 - Installing Log #2 Fig. 21 - Installing Log #3 & Log #4
5 6
7