Integrated Amplifier Instruction Manual 9200

9200 FEATURES

REMOTE CONTROL

Provided with your Plinius 9200 is a three function remote control. The two buttons at the top of the

remote adjust the volume level, and the button below switches the amplifier in and out of mute. Two AAA

batteries power the remote, and these are replaced by removing the two posi-drive screws on the rear face

of the remote that hold the battery compartment in place. The bottom end of the remote is now free to

slide down for access to the batteries. Replace the two batteries, taking care to refit the new ones with

correct polarity.

PHONO GAIN ADJUSTMENT

The phono stage can also be set to high or low gain to suit your phono turntable specifications (high gain

is the factory setting).

Disconnect the lead from the IEC socket on your Plinius 9200 and make sure the Mains switch is OFF.

Carefully remove the lid by undoing the cap screws on the top and side. Locate the small black phono

jumpers to the middle-right side of the top circuit board. The gain can now be adjusted noting that high

gain (factory setting) is set with jumpers to the left, and low gain is set with jumpers to the right. Now re-

assemble your Plinius 9200.

TAPE LOCKOUT PROTECTION

On most tape decks, any signal recorded is sent to the tape outputs so that the signal level of the

recording can be monitored. Should the user accidentally try to record the tape decks own output,

feedback howl usually results. The Plinius 9200 Tape Lockout feature prevents this situation from

damaging your system speakers by muting the power amplifier.

FUSE PROTECTION

When any rail fuse is damaged one or more fuse warning LED’s will light. These LED’s are located next to

the fuse that has blown. To replace the fuse, steady the amplifier, then firmly push in the round fuse cap

with your fingers. When the cap cannot push in any further, rotate the cap anticlockwise (to the left) until

it comes to a stop. Release inward pressure on the fuse cap and it can now be removed from the

amplifier. If any of the rail fuses need to be replaced, do so only with 7.5 amp normal blow fuses.