Integrated Amplifier Instruction Manual 9200

GROUND LIFT SWITCH

This switch allows the signal ground to be disconnected from the chassis. In some installations a hum

loop may exist due to duplicate ground paths from different equipment. Use this switch to remove the

connection from 0V to ground thus allowing some flexibility in your particular set-up.

PROCESSOR SOURCE AND RETURN

These RCA connections are for use with a multi-channel sound processor. They are provided so that you

can use the Plinius 9200 as either two channels in a multi-channel environment, or to send signal through

the amplifier to an external processor.

PROCESSOR SWITCH

This switch is used in conjunction with the processor source and return terminals, and controls whether

the amplifier is used via the normal inputs or the processor return input.

PRE OUT OUTPUT

The Pre-Out connection is provided to enable the Plinius 9200 to be connected to an external power

amplifier. The signal from this output is line level, and as such is not amplified by the power stage of the

Plinius 9200.

MAINS POWER CORD IEC SOCKET

This connector is where the mains supply cable from your wall connects to the amplifier. You will notice

that a fuse holder is mounted within this connection, and it holds a mains fuse to provide surge and

overload protection for your amplifier.

RAIL FUSES

These tubular fuse holders house the positive and negative rail protection fuses. Depress and turn anti-

clockwise to open. An LED is fitted next to each fuse holder to indicate a blown fuse.

PHONO EARTH POST

This is a chassis connected gold-plated earth post for use with most vinyl turntables.