Owner Manual

Control Guide
1) Thermostat
2) Fire Adjustable Switch
3) Switches
a. Fan (without heating)
b. Heat 750W
c. Heat 750W
d. Fire effects
Operating Instructions
 Insert Plug Into Socket
The main switch for the power supply is at the right bottom of the hot air
outlet on the front of the stove. The stove will work when the button is
switch to the “ON” position. A red indicator light will be lit to indicate that
the stove is ON.
Functions
 Open the control panel cover.
 Select the desired function:
- Fire effect (3d)
- Fan (3a) (without heating)
- Half power 750w (3a + 3b)
- Full power 1500w (3a + 3b
+ 3c)
- Heat and fire effect (3a + 3b
+ 3c + 3d)
 Fan function is necessary to activate heat functions.
Without fan the heater cannot run.
 Increase or decrease the fire effect by rotating the fire adjustable switch (2)
until desired intensity.
 To adjust the permanent temperature:
- Turn the thermostat (1) clockwise to the biggest point.
- When the room temperature is comfortable, turn the switch (1)
counter clockwise to break point and keep the button position.
- The function can keep necessary room temperature and also save
energy.
Changing Light Bulbs (See picture below)
CAUTION: Sharp edges!
 Loosen the three screws at the front of the flame effect element
 Lift up the log bed decoration. Two G9 lights are located under the fuel bed.
 Replace the lights with a 25W G9 light.
 To reassemble, follow previous instructions in reverse order.
1
3a 3b 3c 3d 2