Operation Manual
English | 13
Check whether there is network range
at the boiler through the cable (UTP
cable) . Or check your WiFi signal at the
boiler. To do this, use a smartphone or
a tablet that is connected to the WiFi
network to which later on the Smile will
also be connected to.
If your smartphone indicates that
there is a WiFi coverage of at least two
reception bars, you can assume that
this is sufcient.
Unsufcient WiFi coverage near the
boiler? A WiFi repeater can offer the
solution here by amplifying the signal.
Take a picture of the 8-letter code on
the side of the Smile. You will need this
when installing the Anna app.
Go to your boiler. Determine the
approximate position of the Smile.
Connect the adapter cable to the
adapter and the Smile. Plug the adapter
into the wall socket. Wait until the
Smile has booted up: the lights “Status”
and “WLAN” are blinking slowly.
Connect the Smile to your network.
Follow the steps on the next page. Do
this near the boiler. This way you are
sure you are within range.
Keep the Smile ID at hand. You will
need this for connection to the Smile
and for installation in the app.
Keep the password of your WiFi
network at hand. This is necessary for
connecting the Smile to your own WiFi
network.
Connect your smartphone to the WiFi
network that starts with ‘smile_’.
Enter the Smile ID as your password.
Go to http://192.168.40.40 in the web
browser.
The page “Settings” > “Network
settings” will appear automatically.
Press “Scan” and select your own WiFi
network.
Enter the password of your own WiFi
network and save the settings.
Please make sure that you reconnect
your smartphone or tablet to the WiFi
network to which you just set the
Smile.
Check the network coverage.
Connecting to network.
WiFi.
stuvwxyz
ssid: smile_abcdef
Sme
trk na