installation Tools For Model: 873-9570 Basin Wrench Adjustable Wrenches Pipe Wrench Screwdriver Thread Seal Tape Supply Lines Protective Goggles Silicone Sealant Pliers Soft Cloth Single Handle Kitchen Faucet With Pull-out Spray Maintenance Plumbworks® faucets are crafted with the skill and quality to last a lifetime. By following the instructions in this bookie you will enjoy this quality item for bears 1o come To clean, wipe gently with a soft damp cloth, then wipe dry.
Preparation/Assembly (Steps 1-5) 1. Shut off the water supply from the stop valves by turning the handle clockwise and remove the existing faucet from the sink. 2. Remove any dirt or plumber’s putty from around the faucet holes on the sink. 3 . Snap the grooved edges on the hose guide (26) for the side spray into the guide flange (25). Place the unit into the fourth hole in the sink, located on the right side of the faucet. 4.
Assembly (Steps 6-10) 6. Place the spray hose (23) in the hose guide (26) until the side spray (27) rests in the hose guide (26, see inset). 7. From underneath the sink, push the spray hose (23) up through the middle of the three remaining faucet holes. 8. Push the spray hose (23) onto the hose connection on the faucet. Give the spray hose a tug to ensure that it's properly connected. 8.
Assembly (Steps 11-14) 11. Install new water supply lines according to the manufacturer’s installation instructions. Do not reuse existing supply lines. 12. Before turning the water on, unscrew and remove the aerator cover {22) from the faucet spout. If necessary, use pliers and a cloth to protect the finish of the faucet. 13. Open the hot and cold water supply valves. Check for leaks at the shut off valves and the faucet shanks. If leaks occur, tighten the nuts on the water supply lines and shut off valve.
Two Year Warranty Plumbworks® warrants this product o be leak and drip-free during normal household use for fwo years as long as it is owned by the original consumer purchaser. Should a malfunction occur within the time covered by this warranty, replacement parts may be obtained from the place of purchase or from Plumbworks® Customer Service Department at LDR Global Industries LLC, 600 North Bouillon Ave.
