Instructions / Assembly

INSTALLING PLUMBERS EDGE FLANGE FOR CIRCULATOR PUMP

1. DISCONNECT POWER.

2. ISOLATE THE PUMP OR DRAIN THE SYSTEM.

3. INSTALL CIRCULATOR PUMP WHICH MUST BE IN A HORIZONTAL

POSITION AND PARALLEL TO FLOOR.

4. SCREW EACH PLUMBERS EDGE FLANGE ONTO THE INCOMING AND

OUTGOING PIPES OF THE WATER SUPPLY.

5. SET THE CIRCULATOR PUMP BETWEEN THE TWO PLUMBERS EDGE

FLANGES.

6. SCREW THE PLUMBERS EDGE FLANGE TO THE CIRCULATOR PUMP

FLANGE. PLACE THE SCREW THROUGH BOTH FLANGES ON EACH SIDE

AND FASTEN THE NUT AND TIGHTEN. GASKETS (NOT INCLUDED)

SHOULD BE SANDWICHED BETWEEN THE FLANGES.

PAGE 1
INSTALLING PLUMBERS EDGE FLANGE FOR CIRCULATOR PUMP 1. DISCONNECT POWER. 2. ISOLATE THE PUMP OR DRAIN THE SYSTEM. 3. INSTALL CIRCULATOR PUMP WHICH MUST BE IN A HORIZONTAL POSITION AND PARALLEL TO FLOOR. 4. SCREW EACH PLUMBERS EDGE FLANGE ONTO THE INCOMING AND OUTGOING PIPES OF THE WATER SUPPLY. 5. SET THE CIRCULATOR PUMP BETWEEN THE TWO PLUMBERS EDGE FLANGES. 6. SCREW THE PLUMBERS EDGE FLANGE TO THE CIRCULATOR PUMP FLANGE. PLACE THE SCREW THROUGH BOTH FLANGES ON EACH SIDE AND FASTEN THE NUT AND TIGHTEN.