Installation Instructions

INSTALLATION INSTRUCTIONS:
1. Remove the old showerhead from the shower arm
and clean the shower arm threads.
2. In a clockwise direction, apply 2-3 complete wraps
of the thread sealant tape (supplied) to the threaded
end of the shower arm and the adjustable shower arm.
3. Verify that the supplied gasket is in place and tighten
the shower arm nut on the shower arm using adjustable
pliers (not inlcuded). DO NO OVERTIGHTEN. Once installed,
tighten the set screw on the mounting nut using the hex
key (supplied). Use care to avoid damaging the surface
of the shower arm.
4. Attach the showerhead per the manufacturer’s
instructions.
5. To adjust the shower arm: while the water is o, loosen
the levers, rotate the arm to the desired position, then
tighten the levers.
6. Turn on the water and check for leaks. If there are any
leaks, uninstall, apply additional thread sealant tape
and re-install.