OPERATION MANUAL BF-030S PLUS
First of all, we would like to thank you very much for purchasing a Plus Board Fax CONFERENCE MODEL. Please read this Operation Manual before using the machine to get the best performance out of the product. We recommend that you keep this manual for future reference.
BF-030S BOARD FAX CARTON CONTENTS Please be sure all of the following items are included in the carton with the BF-030S BOARD FAX Board Fax main unit ........... 1 ACCESSORIES Set of Dry-eraseble markers (one each black, red and blue).
PRODUCT FEATURES FRONT Board screen 50mm 50mm gridded surface area Tray Printer Operation panel T-shaped stand Printer cover Caster REAR Expansion slot (for optional upgrades) T-shaped stand ( 2 Optional accessory sold separately: PC interface board - to enable downloading of board information from the BF-030S to the PC )
CONTROL FUNCTIONS OPERATION PANEL Opening button ............................. Press this button to open the printer hatch when replacing the thermal paper. Power switch ................................. Press "I" to turn ON the power when starting machine operation. Power lamp .................................... Press the switch, and the green lamp will blink on and off. The lamp will stay lit (green) when the read sensor inside the machine is ready for operation. Paper warning lamp .....................
HOW TO USE BEFORE USE... Press the caster lock switches ON and keep the casters in a locked position. Plug in and turn ON the power switch. After the power lamp blinks for 2-3 seconds, it should turn green. POWER ON POWER WHEN COPYING... When copying one surface: Press the one-surface copy key. At this time the board screen slides forward one page and the written contents are copied onto A4 paper. When copying reduced two-surfaces: Press two-surface reduction copy key.
HOW TO USE WHEN SLIDING THE SCREEN FORWARD... Sliding by using key Press the feed/stop key. Then, the board screen slides to the left by one page and stops. It stops immediately when the feed/stop key is pressed during the sliding operation. Manual sliding It is also possible to slide the board screen manually. In this case, it can be slid in either direction; to the right and left. However, manual sliding at an excessively high speed must be avoided as it occasionally causes problems.
HOW TO USE Push both ends of the hatch closed until it locks with a clicking noise. At this time, make sure that the recording paper has not slipped. Cut off extra recording paper from the printer outlet. Replace the recording paper in the following situations When a red line appears at the edges of the recording paper. The red line will appear when there is only about one meter (3 feet) or so of recording paper left on the roll. When the paper out lamp lights red.
MAINTENANCE/HOW TO STORE Carry out the following maintenance procedures periodically to ensure high quality copying performance at all times. (1) Cleaning of the surface When the surface gets stained, wipe it off with a slightly damp cloth. Also, if the stain is particularly stubborn, use a solution of water-thinned neutral detergent to wipe it off. Do not start using the machine until the sheet has completely dried.
HANDLING PRECAUTIONS 7. When replacing recording paper, do not place any objects on the open printer cover or do not put your elbows on it. 8. After use, make sure to turn OFF the power switch. In addition, when it is not to be used for a long time, make certain that the plug of the power cord is pulled out form the outlet. 9. Always use the correct type of marker. Be careful not to use other markers as the sheet may be damaged or, in some cases, the ink may be difficult to remove. 10.
SPECIFICATIONS Item Specification Board surface size W1300 H920 mm (51-3/16 36 inch) Effective reading size W1240 H880 mm (48-7/8 34-3/4 inch) Number of pages 2 pages Screen driving method One direction endless drive Grid 50mm squares Writing instruments Special markers (black/red/blue) Reading method CCD sensor, plane scanning Recording method Thermal printing with thermal head Recording density 8 dot/mm Recording paper Special thermal sensitive paper (30 m roll) Size of recording
PLUS CORPORATION 3-B22, NAKASE 1-CHOME, MIHAMA-KU, CHIBA 261-8501 JAPAN PHONE: 043-296-3056 FAX: 043-296-3025 TELEX: J22113 PLUSJIM, CABLE PLUSJIMUK TOKYO