Datasheet

BITalino Mini Solo
Datasheet
PAGE 3 OF 5
Fig. 3. BITalino Mini Solo PINOUT Top
PINOUT DIAGRAM BACK
Fig. 4 - BITalino Mini Solo PINOUT Bot
> Power Supply Jumper: Allows you to choose between the power supply dedicated to
the analog or digital circuits depending on the sensor you want to connect to the UC-E6
port.
> Analog/Digital Jumper: By default, the embedded UC-E6 port is connected to the
analog A1 channel. In order to plug a digital sensor into the UC-E6 port, cut* the jumper
pad connecting the A1 channel to it and solder* the jumper to the I1O1 pad to enable
digital communication with the device via the UC-E6 port.
* Always verify the cuts and solders are properly done using a multimeter.
> BLE/UART Jumpers: Cut these jumpers to virtually detach the BLE module from the
Microcontroller and enable communication with the MCU through UART communication.
NOTE : For devices with version number V.200828 the header hole with the label ‘ABAT’
is connected to ‘DVCC’ and the header hole with the label ‘A7’ is connected to ‘ABAT’.
Fig. 5 - BITalino Mini Solo Label Note