Instruction Manual

Setting up the DM-6 Multi Gauge to the SM-AFR

Navigating the DM-6

ere are a total of 3 capacitive touch buttons on the DM-6. ey are highlighted in the image below.

Use the le button to toggle between sensors.*

In the Peak/Hold view, holding the right button will open a menu option

to save or reset current/all peak/hold values.

Use the right button to toggle between Numeric, Graph, and Peak/Hold

screen views.

Hold the logo button to display unit label and range. Le and right values

refer to entire LED sweep range.

* - Sensors available are based on Sensor Modules in daisy chain. Dis-

play order is based on location of the Sensor Module in the daisy chain

e Menu

Pressing and holding both le and right buttons together will take you into the menu system. Once

inside the menu system, use the le button to save changes, the logo button to select which menu item is

currently selected, and the right button to access the current selection option. Please note the icons used.

PAGE 1
Setting up the DM-6 Multi Gauge to the SM-AFR Use the right button to toggle between Numeric, Graph, and Peak/Hold screen views. Hold the logo button to display unit label and range. Left and right values refer to entire LED sweep range. Navigating the DM-6 There are a total of 3 capacitive touch buttons on the DM-6. They are highlighted in the image below. In the Peak/Hold view, holding the right button will open a menu option to save or reset current/all peak/hold values.
PAGE 2
Setup Unit To setup the unit for a particular sensor, follow the procedures listed below: 1. Hold both left and right button to get into the “SETUP MENU”. 2. Press the right button to get into “SETUP UNIT” screen. 3. To change the sensor, press the right button. 4. To change the unit for that particular sensor, press the logo button to move down the arrow. 5. Press the right button to change the unit. 6. Press the left button to save and go back to the “SETUP MENU” screen.