MORTARLESS COLUMN INSTALLATION GUIDE FREESTANDING STONE COLUMN Beauty made simple.
MORTARLESS COLUMN MODULAR STACKING SYSTEM Freestanding Stone Column Installation Once you have completed the Before You Begin and Before Construction requirements below , you may construct your column on level or uneven ground by following these instructions: Before You Begin PREPARE THE HOLE 1. Remove and discard an 18" X 18" square of sod and/or grass roots from the solid ground where you wish to install your column.
1” 18” 10” 10” 18” 18” SETTING THE POST 4. Set the 5" X 5" PVC post in the center of the hole. Measure, mark and cut to the appropriate height. For a 13 segment column with cap, the post should extend 76" above ground level. (If underground electrical connections are planned, the post should be prepared according to local regulations at this time.) 5. Center the measured and cut PVC post in the hole atop the gravel base. 6.
FREESTANDING COLUMN CONTINUED show from the exterior once the column sections are stacked). NOTE: The top of the stone sections have a raised bevel designed to rest in the beveled indent at the bottom of the next stone section. 11. Once adhesive is applied, lower the Stone Column sections over the post and into place until the desired column height is achieved. 12.