MP-800 Installation Manual Need support? Please find the user manual and contact us.
Unit Installation 1. Please confirm whether your DASH is suitable for the MP-800. If not, please buy the right DASH KIT for your car or modify your DASH KIT. 2. Different car models need different accessories( DASH KIT / aftermarket harness adapter/antenna adapter), you can find the correct aftermarket accessories by searching the year, make, and model of your vehicle on Amazon or Google. 3. Install the brackets after connecting the wiring harness and antenna. Bracket Screw a.
Wire Connection 02
Wire Connection For example: Step1: Purchase aftermarket wiring harness adapter Aftermarket wiring harness adapter NOTE: different car model has different aftermarket wiring harness adapter. General aftermarket wiring harness adapter definition NOTE: Please refer to the definition of your actual aftermarket wiring harness adapter you purchased. You should buy an aftermarket wiring harness adapter for your car.
Step2: Connect aftermarket wiring harness adapter to MP-800 harness MP-800 harness ▶Match the wires on your aftermarket wiring harness adapter and the wires on MP-800 harness according to the definition. ▶Twist matching wires together and cover the splice and unused bare wires with electrical tape to avoid short circuits. Step3: Plug wiring harness ▶Plug your aftermarket wiring harness adapter into your vehicle's factory wiring harness. ▶Plug MP-800 harness into the back of MP-800 car stereo.
Step4: Plug in the radio antenna. Step5: Test whether MP-800 car stereo works properly Necessary conditions for MP-800 car stereo works properly : 1. The Yellow wire (+12V Memory Backup ) of the MP-800 harness has 12V output. 2. The Red wire (+12V Ignition Switch) of the MP-800 harness has 12V output when the car key is on. 3. The Black wire (Ground wire) of the MP-800 harness is valid. Q: It doesn't work after installation.
Reason 2: You likely have a loose connection. Solution: Make sure that your vehicle's factory wiring harness and aftermarket wiring harness adapter are securely attached. Ensure that the MP-800 car stereo plug is properly and tightly plugged into the back of the MP-800 stereo. Reason 3: The MP-800 was damaged in transit. Solution: Please scan the QR code and find the video named "How to test if the car stereo works before installing ".
Rear Camera Installation Camera Power: Connect to the reversing light Monitor Camera Input Connect Orange back view trigger Red: Reversing Light +12V Reversing Light Black: Ground- Rear Camera 07
Front Camera Installation Camera Input Red: +12V Ignition Switch Black: Ground Wire (B-) Front Camera NOTE: The picture is only for installation reference, front camera not included.
Connect Amplifier To The MP-800 2 channel amplifier Blue/Black Wire: AMP Control 09
4 channel amplifier Divided into two sets with splitter Blue/Black Wire: AMP Control 10
How to set steering wheel control buttons 1.Find your steering wheel control wire of the original vehicle(KEY1/KEY2/ ground wire) 2.KEY1 connecting brown wire, KEY2 connecting brown black wire, KEY GND the grounding wire.(Please refer to the actual harness) Please scan the QR code and find the video named "How to set steering wheel control buttons ". Car Stereo Manufacturer NOTE: MP-800 is designed to be connected to your vehicle' steering wheel control wire directly.
