User Manual

11
Handling PHV1000
Handle with care especially when fitted with the sharp spring contact tip to avoid any injury.
Note that the probe cable is a sensitive part of the probe. Do not damage through excessive
bending or pulling. Avoid mechanical shock to this product in general to guarantee accurate
performance and protection.
Maintenance
Cleaning
To clean the exterior of the probe use a soft cloth moistened with either distillated water or isopropyl alcohol.
Before use allow the probe to dry completely.
Changing the probe tip
To change the probe tip use pliers to grip and pull it carefully straight out of its contact socket, along the axis of
the probe. Do not grip the white plastic insulator or the housing with pliers, because this will damage the probe
tip. If the probe tip is removed, the new tip can be inserted with pliers into the contact socket, along the axis of
the probe. To insert the probe tip completely into the housing, press the probe tip against a hard surface
carefully.
Use pliers to grip and pull the probe carefully out of
its contact socket.
Do not grip the white plastic insulator or the probe
housing with pliers.