Datasheet

PMTG 321A

Datasheet

This datasheet supersedes all previously published material. Specifications that are defined typical

are not guaranteed and are published as general information to the user. The instrument should

have warmed up for at least 20 minutes and the environmental conditions must not exceed the spe-

cified limits of the probe. Note that specifications are subject to change without notice.

Electrical specifications

Attenuation ratio (switchable)

(1)

1:1 10:1 ± 2 % at DC

(at 10:1)

Voltage coefficient – 0.0025 % / V (typical)

System bandwidth 20 MHz

(2)

350 MHz (-3 dB)

Probe risetime 17.5 nsec 1 nsec (10 % – 90 %)

(typical)

Maximum rated input voltage

(3)

Measurement category I: – 400 V rms

1250 V transient overvoltage

Measurement category II: 55 V rms CAT II 300 V rms CAT II

Pollution degree 2

Voltage derating

(1) Connect to oscilloscope with an input impedance of 1 MΩ ± 1 %.

(2) at 15 pF input capacitance of the measuring instrument.

(3) As defined in IEC 61010-031.

Note that the max. input voltage

rating of the probe decreases as

the frequency of the applied signal

increases.

Typical voltage derating PMTG321A (switched to 10:1)

Measurement category I

100

200

300

400

0,1 1 10 100 1000

Frequency [MHz]

Amplitude AC rms [V]sinus