Instruction Manual

MicroMag User Manual – March 2010 Page 3 of 23
List of Figures
Figure 3-1: Temperature Characteristics ................................................................... 7
Figure 3-2: Linearity vs. Temperature ....................................................................... 8
Figure 3-3: Linearity vs. Temperature, Normalized to Room Temperature ................ 8
Figure 3-4: MicroMag2 Mechanical Drawing............................................................. 9
Figure 3-5: MicroMag2 Suggested SMT Footprint .................................................... 9
Figure 3-6: MicroMag2 3-D View with Component Call-Out .................................... 10
Figure 3-7: MicroMag2-on-Carrier Mechanical Drawing ......................................... 11
Figure 3-8: MicroMag2-on-Carrier 3-D View ........................................................... 11
Figure 3-9: MicroMag3 Mechanical Drawing........................................................... 12
Figure 4-1: MicroMag2-on-Carrier Reference Block Diagram ................................. 15
Figure 5-1: SPI Port Full Timing Sequence ............................................................. 20
Figure 5-2: SPI Port Timing Parameters ................................................................. 20
List of Tables
Table 3-1: Absolute Maximum Ratings...................................................................... 6
Table 3-2: Module Operating Characteristic .............................................................. 6
Table 3-3: MicroMag2 Component Call-Out ............................................................ 10
Table 3-4: MicroMag2-on-Carrier Component Call-Out ........................................... 11
Table 4-1: Pin/Pad Indentifier Table ........................................................................ 14
Table 4-2: Maximum Delay for DRDY ..................................................................... 17
Table 5-1: Command Byte ...................................................................................... 21
Table 5-2: Axis Select ............................................................................................. 21
Table 5-3: Period Select ......................................................................................... 22