Instruction Manual

PNI Sensor Corporation Doc #1016102 r04
RM3000-f & RM2000-f Sensor Suite User Manual Page 16
Dimensions in mm
Full reel is 1200 pcs. Smaller quantities on cut tape.
Tape & reel meets ANSI/EIA standard EIA-418-B
Figure 3-11: Sen-Z-f Tape and Reel Dimensions
Note: PNI recommends a 5 mil stencil. The solder paste area is much smaller than the pad to reduce
sensor tilt and misalignment. The above layout allows for rework: for minimal footprint, contact PNI.
Figure 3-12: Sen-Z-f Recommended Solder Pad, Paste, & Mask Layout