Solid State Drive Installation Guide Make Life Simple ™
IMPORTANT CONSIDERATIONS – Please read before you begin • Your new PNY SSDs is a 2.5” SATA II ( Serial ATA 2nd generation ) drive, and is backwards compatible with SATA I. Please consult your system specifications for compatibility. • If you are installing this SSD in a desktop system or server, you may need a 3.5” drive bay adapter ( not included with the PNY SSD ).
Installation steps 1 Turn off the notebook power. 2 Disconnect all notebook power cables. 3 Turn the notebook upside down and remove the battery. 4 Locate the hard drive panel on the bottom of your notebook (Refer to your user manual). 5 Unscrew and remove the panel. 6 If there is a tab on the existing hard drive, gently pull it up and then to the outside to remove the hard drive from the bay.
