User's Manual

(33) Alarm Mode (AL-MOD) - MENU No.32
This function can set the tone alarm/code alarm/site alarm of the radio.
Keep pressed the [CALL] key for 3 seconds to start the alarm tone.
The following three options can be selected:
• SITE: the speaker emits an alarm tone but the radio doesn’t transmit;
• TONE: the speaker emits an alarm tone and the radio transmits it;
• CODE: the speaker emits an alarm tone and the radio transmits it followed by ANI-ID code.
(35) Dual Watch (TDR-AB) - Menu No.34
When this function is on, you may receive signals of A/B channel or frequency. It can also be used for cross band receiving
and transmitting. You can choose amongst the following settings:
OFF: it can receive in both VFO (not simultaneously); ▲ or ▼ will blink on the transmitting frequency band.
A: the radio can receive in both VFO (not simultaneously) but can transmit in VFO A only.
B: The radio can receive in both VFO (not simultaneously) but can transmit in VFO B only.
If you choose option A, it means that 432.5875MHz is the tx frequency band, while 145.550MHz is the rx frequency band;
the upper VFO shows 432.5875 MHz while in the lower VFO 145.550MHz will be displayed; you can receive on both
432.5875 MHz and 145.550 MHz, but can transmit on 432.5875 MHz only.
While if you choose option B, 145.550MHz is the tx frequency band and
432.5875MHz is the rx frequency band. In the upper VFO 432.5875 MHz will be
displayed while the lower VFO will show 145.550 MHz; you can receive on both
432.5875 MHz and 145.550 MHz, but transmit on 145.550 MHz only. Example:
the LCD displays
(36) Side tone elimination (STE) - Menu No. 35