User Manual

4.2 Main controls and parts of the radio
LCD Display
1. Received signal strength.
2. High/Low power selection.
3. Appears when DTMFST (DT-ST / DT + ANI / ANI-ST) is activated.
4. These symbols show that you set a DCS or CTCSS code in tx or rx. In tx mode it appears while you are transmitting, while
in rx mode it is shown also in stand-by condition.
5. Appears when a positive shift is activated.
6. Appears when a negative shift is enabled.
7. This letter is displayed when the Dual Watch function is active.
8. This icon indicates the keypad lock. To unlock it press [*
].
9. VOX function enabled.
10. Reverse frequency
11. Narrow bandwidth: N = narrow. When the wide (W) bandwidth is activated, no icon is displayed.
12. Battery level indicator. When the battery is almost used up, the icon starts blinking and the transmission is blocked.
Charge the radio.