User Manual

NOTE: To ensure the best reception volume, keep the distance between the microphone and the mouth at the time of
transmission from 2.5 cm to 5 cm.
5.4 Channel selection
There are two modes of operation: Frequency (VFO) mode, and Channel or Memory (MR) mode.
For everyday use, Channel (MR) mode is going to be a whole lot more practical than Frequency (VFO) mode. However,
Frequency (VFO) mode is very handy for experimentation out in the field. Frequency (VFO) mode is also used for
programming channels into memory.
In Channel (MR) mode you can navigate up and down the channel by using the ▲ /▼ keys or the encoder.
Ultimately which mode you end up using will depend entirely on your use case.
5.5 Frequency (VFO) mode
In Frequency (VFO) mode you can navigate up and down the band by using the ▲ /▼
keys. Each press will increment or decrement your frequency according to the frequency step
you've set your transceiver to.
You can also input frequencies directly on your numeric keypad with kilohertz accuracy.
The following example assumes the use of a 12.5 kHz frequency step.
Example. Entering the frequency 436.61250 MHz on display A
a. In standby mode, press and hold the [MENU] key to switch to the frequency (VFO) mode.
b. Press [EXIT] until the  icon appears next to the upper display. .
c. Enter [4][3][6][6][1][2][5] [0] on the numeric keypad.
WARNING!
Just because you can program in a channel does not mean you're automatically authorized to use that frequency.
Transmitting on frequencies you're not authorized to operate on is illegal, and in most jurisdictions a serious offence.
However, it is legal in most jurisdictions to listen. Contact your local regulatory body for further information on what
laws, rules and regulations apply to your area.