User Manual

a. In standby mode, press [MENU] [3][1], “SEEK” will appear on the display.
b. Press [MENU] and the scan of CTCSS tones will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.4 DCS scanning
This function allows scanning the frequencies with DCS code enabled.
a. In standby mode, press [MENU] [3][2]; the display will show “SEEK”.
b. Press [MENU] and the scan of DCS codes will start.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
6.5 Cursor Conversion (A/B)
Directly press [EXIT] key to move the cursor up and down. Then, you can modify or confirm the parameters indicated by
the cursor.
Important1: The radio has a dual-frequency display function. In frequency mode, you will see on the display two different
receiving and transmitting frequencies; while in channel mode the two different channels will be displayed.
Important2: In frequency or channel mode, press the [EXIT] key to shift between the main channel A and the sub-channel
B
on the display indicates on which channel (main channel A or sub channel B) you are operating.
6.6 High/low power fast selection
In channel mode, press [#SCAN] key to shift between High/ Low power.
6.7 Keypad lock
This function locks the keypad to prevent accidental pressure of the controls.
To unlock the keypad, press [*
] for more than 2 seconds.