User Manual

(13) Transmitting DCS (Tx DCS) - MENU No.12
In this Menu you activate DCS codes in tx mode. You can choose between normal R-DCS (D023N-D754N) and inverted
R-DCS (D023I-D754I)
Note: the groups of DCS codes are 208. DCS codes cannot be changed in channel mode.
(14) Transmitting CTCSS (Tx CTCSS) - MENU No.13
In this Menu you can set a CTCSS tone in tx mode.
You can choose: Off or CTCSS (67.0 to 254.1 Hz)
Note: there are 50 groups of CTCSS tones. In channel mode the CTCSS tones cannot be changed.
(15) Voice prompts function (Voice) - MENU No. 14
With this function, you activate a voice that informs you about any operation/ selection you are doing.
(16) ANI-ID (ANI-ID) - MENU No.15
With this function you can set your ID-code. It can be programmed by the proper programming software. You can edit up
to 5 digits.
(17) DTMFST (DTMFST) - MENU No.16
Determines when DTMF Side Tones can be heard from the transceiver speaker. You can choose amongst four options:
• Off: No DTMF Side Tones are heard
• DT-ST : Side Tones are heard only from manually keyed DTMF codes
• ANI-ST: Side Tones are heard only from automatically keyed DTMF codes
• DT+ANI: All DTMF Side Tones are heard
(18) Signal code (S-CODE) - MENU No.17
Selects 1 of 15 DTMF codes. The DTMF codes are programmed with software and are up to 5 digits each.