User Manual

(19) Scan Add (Scan Add) - MENU No.18
In channel mode, to scan the current channel, the channel must be added to the scan group.
On: Turn on the scan function of the current channel.
Off: Do not scan the current channel.
(20) Scan ranger (Scan Ran) - MENU No.19
In frequency mode, the frequency sweep range can be precisely set. Input the start value and end value of the sweep
frequency through the keyboard.
EX: Enter 144146, in frequency mode, scan in the range of 144.000-146.000MHZ. Enter 430450, in frequency mode, scan in
the range of 430.000-450.000MHZ.
Note: channel mode, the set frequency range is invalid and cannot be saved.
(21) SCAN Resume Mode (Scan Mode) - MENU No.20
Thanks to this function, the radio can SCAN in frequency or channel mode. You can choose amongst three options:
Time-operated SCAN
Whenever a signal is detected, the radio will suspend the SCAN for 5 seconds, and then will continue to SCAN even if the
signal is still present.
Carrier-operated SCAN
Whenever a signal is detected, the radio will stop scanning. It will resume to SCAN once the signal will disappear.
Search -Search SCAN
The radio will stop scanning once a signal is detected.
(22) PTT-ID (PTT-ID) - MENU No.21
With this function you can decide when sending the ANI-ID code in tx mode.
You can choose amongst 4 possibilities.
Off: press PTT to turn it off
BOT: the code is sent when you press the PTT