User Manual

Page5/15
electronics).
6) When the power supply is cut off, the GPS shows a screenshot
to ask if you want to shutdown the device. If you don't choose any
options it shows, the device will turn off automatically after 10s.
7) If your GPS won't be charged, try with the main charger or
another car charger. Facing with the charge problem, please
contact us.
[Attention!]
The GPS navigator adopts internal non-removable Li-polymer
battery. To avoid battery rupture, explosion, release hazardous
substance or burn, do not unpack, pierce, strike on or discard the
battery in fire or water.
GPS S
ignal
Search: Not showing the 8rrect map location after
entering navigation
1) When first starting up your GPS, you are suggested to have GPS
unit fully charged and then go outdoors to search for satellite. It will
take about 30 minutes. If the GPS signal is strong enough, the unit
will locate your current location automatically.
2) On the main menu, click 'GPS Info', there are 12 channels. If
more than 3 channels have caught satellite, the signal of the GPS unit
is good.
3) If not showing the correct map location after entering
navigation, please check if the map of your location has been
preloaded after finishing step1) and step 2) above. You can check it
as the following way: Navigation-Destination-find address-enter an
address around your location.
Connecting a Computer
Turn on the GPS unit and check the USB setting first: Main menu
→
Setting→ USB→ choose 'Mass Storage'.
When connecting, a flashing USB stick on the screen which means it
has been recognized by the computer successfully. Please notice that
you need to tum on your GPS device first, while connecting to a
computer. Otherwise, it won't be recognized.
[Attention II
You cannot use the GPS unit, while connecting to a computer. It
works only as a flash drive.
Navi Path Setting
Tum on the GPS unit and set Navi Path: click 'Main Menu' →
'Settings'
→
'Navi Path'. Click the grey button on the right side of
'Navigation exe file path': double click 'ResidentFlash' → double
click 'Navi' → double click 'Navi.EXE' → Click on the green icon
in the upper right comer Then it will go back to page 'Navi Path'.
Now, it's done.
Language Settings
For language setting, there are :
1) Main menu: Settings → Language → and then set the
language you want. You can scroll down for more languages.
2) For the language when entering the navigation: please go
"Main menu → Navigation → Settings(Tools icon: )
3Regional(Flag icon)
→
Program Language(The first line)
→
set
the language-Done”. Then restart the Navigation program.