User's Manual

User Manual（FCC&IC） Draft
Model: BF-88A
following:
Use only the supplied or an approved antenna.
Unauthorized antennas, modifications, or
Attachments could impair call quality, damage the radio, or result in violation of FCC regulations.
Do not use the radio with a damaged antenna.
If a damaged antenna comes into contact with the skin, a minor burn may result. Please contact your local dealer for a
replacement antenna.
Any attempt to change frequencies or output power of the radio invalidates the approval.
■ FCC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause
harmful interference.
Our radio generators RF electromagnetic energy during transmit mode. This radio is designed for and classified as "
General Population”,meaning it must be used only during the course of employment by individuals aware of the hazards,
and the ways To Minimize Such hazards.
This radio is NOT intended for use by the” Occupational Use Only” in an uncontrolled environment. This radio has been
tested and complies with the FCC RF exposure limits for“General Population”. In addition, our radio complies with the
following Standards and Guidelines with regard to RF energy and electromagnetic energy levels and evaluation of such
levels for exposure to humans:
---IEEE Std. 1528:2013 and KDB447498, Evaluating Compliance with FCC Guidelines for Human Exposure to Radio
Frequency Electromagnetic Fields.
---American National Standards Institute (C95.1-1992), IEEE Standard for Safety Levels with Respect to Human Exposure
to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
---American National Standards Institute (C95.3-1992), IEEE Recommended Practice for the Measurement of Potentially
Hazardous Electromagnetic Fields-RF and Microwave.
The information listed above provides the user with the information needed to make him or her aware of RF exposure,
and what to do to as-sure that this radio operates with the FCC RF exposure limits of this radio.
Electromagnetic Interference/Compatibility
During transmissions, The radio generates RF energy that can possibly cause interference with other devices or systems.
To avoid such interference, turn off the radio in areas where signs are posted to do so. DO NOT operate the transmitter in
areas that are sensitive to electromagnetic radiation such as hospitals, aircraft, and blasting sites.
Occupational/Controlled Use
The radio transmitter is used in situations in which persons are exposed as consequence of their employment
provided those persons are fully aware of the potential for exposure and can exercise control over their exposure.
Attention:
This radio complies with IEEE and ICNIRP exposure limits for General Population RF exposure environment
at operating duty factors of up to 75% and is authorized by the FCC for General Population. An appropriate
warning label is affixed to all units. In order to comply with RF exposure requirements, a minimum distance of
2.5 cm must be maintained when held-to-face, and body-worn operations are restricted to the approved original
accessories (belt clip), a minimum distance of 0 cm. Do not use this device when antenna shows obvious damages.
■ IC COMPLIANCE
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to
operate the equipment.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences
et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée
aux deux conditions suivantes :
(1) cet appareil ne doit pas causer d’interférences nuisibles et
(2) il doit pouvoir accepter les interférences, incluant celles pouvant nuire à son fonctionnement normal.
Tout changement ou modification non approuvé expressément par la partie responsable pourrait annuler le droit à
l’utilisateur de faire fonctionner cet équipement.
This EUT is compliance with SAR for uncontrolled exposure limits in IC RSS-102 at operating duty factors of up to 50% and