Operating Manual

(18) Signal code (S-CODE) - MENU No.17
Selects 1 of 15 DTMF codes. The DTMF codes are programmed with software and are up to 5 digits each.
(19) SCAN Resume Mode (Scan Mode) - MENU No.18
Thanks to this function, P10UV can SCAN in frequency or channel mode. You can choose amongst three options:
• Time-operated SCAN
Whenever a signal is detected, the radio will suspend the SCAN for 5 seconds, and then will continue to SCAN even if the
signal is still present.
• Carrier-operated SCAN
Whenever a signal is detected, the radio will stop scanning. It will resume to SCAN once the signal will disappear.
• Search -Search SCAN
The radio will stop scanning once a signal is detected.
(20) PTT-ID (PTT-ID) - MENU No.19
With this function you can decide when sending the ANI-ID code in tx mode.
You can choose amongst 4 possibilities.
• OFF: press PTT to turn it off
• BOT: the code is sent when you press the PTT
• EOT: the code is sent when the PTT is released
• BOTH: the code is sent when you press and release the PTT
Note: select ‘OFF’ when using in case of affecting the radio.
(21) Channel A Display Mode (MDF-A) - MENU No.20
This function is used to set the display mode of channel A.
Display modes:
• Frequency: Frequency + channel No.
• NAME: Channel name