Operating Manual

(26) Frequency offset (Offset) - MENU No. 25
In this MENU you can set the deviation between tx and rx. The frequency offset of this radio is 00.000-99.998MHz.
(27) Channel store - (Memory) - MENU No. 26
When the radio is in frequency working mode or standby mode, input the desired frequency or parameters directly.
NOTES: If you want to set CTCSS tones, DCS codes or the frequency offset, you have to do it before storing the channel.
The channels already stored are displayed as CH-XXX ("CH" and -channel number), and other channels only display
channel numbers.
(28) Channel Delete (Delete) - MENU No.27
In this menu you can delete a channel of the radio.
(29) Alarm Mode (Alarm Mode) - MENU No.28
This function can set the tone alarm/code alarm/site alarm of the radio.
Keep pressed the [SK1] key for 3 seconds to start the alarm tone.
The following three options can be selected:
• On site: the speaker emits an alarm tone but the radio doesn’t transmit;
•Send sound: the speaker emits an alarm tone and the radio transmits it;
• Send code: the speaker emits an alarm tone and the radio transmits it followed by ANI-ID code.
(30) Scan of frequencies with CTCSS (Scan CTCSS) - Menu No. 29
The function allows scanning the frequencies with CTCSS tone enabled.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
(31) Scan of frequencies with DCS (Scan DCS) - Menu No. 30
This function allows scanning the frequencies with DCS code enabled.