Operating Manual

30
Scan DCS -Scan of
frequencies with
DCS
MENU+30
D023N,…,D754I
*Automatic stop after receiving the DCS signal
31
STE - Squelch Tail
Elimination
MENU+31
ON
OFF
*This function is used eliminate squelch tail noise
between POFUNG handhelds that are
communicating directly (no repeater). Reception of
a 55 Hz or 134.4 Hz tone burst mutes the audio long
enough to prevent hearing any squelch tail noise.
32
RP-STE-Squelch
Tail Elimination
MENU+32
OFF/ 1,2,3…10
*This function is used eliminate squelch tail noise
when communicating through a repeater.
33
RPT-RL - Delay the
squelch tail of
repeater
MENU+33
OFF/ 1,2,3…10
*Delay the Tail Tone of Repeater (X100 milliseconds)
34
ROGER - Roger
Beep
MENU+34
OFF
ON
*Sends an end-of-transmission tone to indicate to
other stations that the transmission has ended.
35
R-TONE–Repeater
Tone
MENU+35
1000Hz/1450Hz/1750Hz/2100Hz
*To send out a repeater tone; You hold down the
[PTT] + [SOS] key.
36
Power On Msg
-Power On
Message
MENU+36
Preset Logo: Performs an LCD screen test at
power-on
Preset Msg : Displays a 2-line power on message
Voltage: