Safety Information

(15) ANI-ID (ANI-ID) - MENU No.14
With this function you can set your ID-code. It can be programmed by the proper programming software. You can edit up to
5 digits.
(16) DTMFST (DTMFST) - MENU No.15
Determines when DTMF Side Tones can be heard from the transceiver speaker. You can choose amongst four options:
• Off: No DTMF Side Tones are heard
• DT-ST : Side Tones are heard only from manually keyed DTMF codes
• ANI-ST: Side Tones are heard only from automatically keyed DTMF codes
• DT+ANI: All DTMF Side Tones are heard
(17) Signal Code (S-CODE) - MENU No.16
Selects 1 of 15 DTMF codes. The DTMF codes are programmed with software and are up to 5 digits each.
(18) Scan Add (Scan Add) - MENU No.17
In channel mode, to scan the current channel, the channel must be added to the scan group.
•On: Turn on the scan function of the current channel.
•Off: Do not scan the current channel.
(19) Scan ranger (Scan Ran) - MENU No.18
In frequency mode, the frequency sweep range can be precisely set. Input the start value and end value of the sweep
frequency through the keyboard.
EX: Enter 144146, in frequency mode, scan in the range of 144.000-146.000MHZ. Enter 430450, in frequency mode, scan in
the range of 430.000-450.000MHZ.
Note: channel mode, the set frequency range is invalid and cannot be saved.
(20) SCAN Resume Mode (Scan Mode) - MENU No.19