Operating Manual

set.
b. You can change the scanning direction with the ▲and ▼ keys.
c. Press any key to stop scanning.
Note: for Scan mode, see Menu No.18.
6.3 Search CTCSS/DCS Code
With this function you can search and store the CTCSS/DCS code used by other radios.
Procedure:
a. In frequency mode press [MENU]+[1][1].
b. Press [MENU] key again.
c. Press [*scan] key; CT will blink on the display.
d. When another radio is transmitting, the display will show the CTCSS/DCS code.
e. After searching the CTCSS code, the radio will beep and stop scanning.
f. After setting, press [MR/VFO] key for confirmation and store, or press [PTT] or [EXIT] key to return to standby mode.
NOTE 1: the DCS scanning has the same procedure of CTCSS code, but you have to select MENU+10 to enter scanning.
NOTE 2: if CTCSS has not searched the code, you can search using the DCS mode.
6.4 Cursor▼▲Conversion (A/B)
Directly press [A/B] key to move the cursor up and down. Then, you can modify or confirm the parameters indicated by the
cursor.
Important1: UV5R PRO has a dual-frequency display function. In frequency mode, you will see on the display two different
receiving and transmitting frequencies; while in channel mode the two different channels will be displayed.
Important2: In frequency or channel mode, press the [A/B] key to shift between the main channel A and the sub-channel B
▲ on the display indicates on which channel (main channel A or sub channel B) you are operating.