Operating Manual

32
AL-MOD - Alarm Mode
MENU+32
SITE: Sounds alarm through your radio speaker only
TONE: Sending alarm tone
CODE: Sending alarm code
33
BAND - Band Selection
MENU+33
VHF:144-148,UHF:430-450 (Canadian IC standard)
VHF:144-146,UHF:430-440 (EU CE standard)
*In VFO/Frequency mode, sets [A] or [B] to the VHF or
UHF band.
34
TDR-AB - Transmit
selection while in Dual
Watch mode
MENU+34
OFF
A band transmit (Upper row frequency)
B band transmit (Bottom row frequency)
*When enabled, priority is returned to selected display
once the signal in the other display disappears.
35
STE - Squelch Tail
Elimination
MENU+35
ON
OFF
*This function is used eliminate squelch tail noise
between Baofeng handhelds that are communicating
directly (no repeater). Reception of a 55 Hz or 134.4 Hz
tone burst mutes the audio long enough to prevent
hearing any squelch tail noise.
36
RP-STE-Squelch Tail
Elimination
MENU+36
OFF/ 1,2,3…10
*This function is used eliminate squelch tail noise when
communicating through a repeater.
37
RPT-RL - Delay the
squelch tail of repeater
MENU+37
OFF/ 1,2,3…10
*Delay the Tail Tone of Repeater (X100 milliseconds)
38
PONMSG-Power On
Message
MENU+38
FULL: Performs an LCD screen test at power-on
MSG : Displays a 2-line power on message
*Controls the behavior of the display when the
transceiver is turned on.
39
ROGER - Roger Beep
MENU+39
OFF
ON
*Sends an end-of-transmission tone to indicate to other