User's Manual

3.3. LED Indicators

The red LED is ON while charging the battery and the green LED is ON when the battery is fully

charged.

Alternatively, it is also possible to recharge the battery pack by using the single slot cradle, the

single Ethernet cradle or the 4-slot battery charger.

During the charging process the LED positioned at theleftupper side of the display is red constant.

Once the charging process has been completed this LED is green constant.

If the battery pack is removed from the handy terminal, it can be recharged by inserting it into the

rear slot of the single slot cradle, the single Ethernet cradle or the 4-slot battery charger.

3.4. Guidelines for Battery Pack Use and Disposal

The following are general guidelines for the safe use and disposal of batteries:

 Storethe terminal and the spare batteries between 20 to 30 ºC (68 to 86 ºF)in order to

maintain optimal battery performance.

 Standard batteries must be charged at a temperature ranging from0 to 45℃(±3℃).

 The battery level may not be displayed correctly for some minutes after the disconnection if

the handy terminal is disconnected from power supplybefore the charging cycle is completed.

 The handy terminal could get warm during charging. This is normal and does not mean a

malfunction.

 To achieve the best battery life, turn off the radios not in use.

 Rechargeable battery packs isnot initially charged. Therefore the initial operation to perform is

to charge them. See below.

 By default, the battery pack is disconnected at the factory to avoid damage due to excessive

draining.Annual replacement of rechargeable battery pack avoids possible risks or

abnormalities and ensures maximum performance.

WARNING:

DO NOT attempt to charge damp/wet handy terminals or batteries. All components must be dry

before connecting to an external power source.

AVERTISSEMENT :NE PAS tenter de recharger les terminaux ou les batteries encore humides lorsqu’ils ont été

mouillés. Tous les composants doivent être impérativement séchés avant la connexion à une source d'alimentation

externe.