User's Manual

4.21. Suspend Mode

Suspend Mode suspends terminal operation. The terminal appears to be “off” when in Suspend

Mode. The terminal is programmed to go into Suspend Mode automatically when inactive for a

specified period of time. You can set this time period in the Power setting.

To suspend and resume operation, press the Power button. You may also press the front Scan key

to wake a suspended device unless the battery door has been removed and replaced.

☞NOTE:

You should always put the terminal in Suspend Mode when you change the battery pack; see Changing the

Battery Pack on paragraph 4.18.

Troubleshooting Suspend/Resume

If the terminal does not wake when you press the Power button, the main battery might be too low

to resume operation. To check, remove the battery and install a fully charged battery or connect the

terminal to a Handy Terminal charging peripheral.

4.22. Memory Allocation

You can verify file storage and program memory in System Properties.

1. Tap Start ->Settings ->Control Panel ->System ->Memory tab.

4.23. Care and Cleaning of the Products

When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-

free cloth. The terminal can be cleaned with a damp cloth.

4.24. PM200 Technical Specifications

Model PM200

Operating System Microsoft Windows Embedded CE 6.0 Core

Application Software Tools and Demos