User's Manual

1. Attach the appropriate plug to the power adaptor.

2. Plug the power cable into the power source.

3. Plug the connector into the DC power jack on the back panel. The base is now powered.

When a terminal is properly seated, the base powers the terminal, charges the terminal’s main

battery pack, and launches ActiveSync (see ActiveSync Communication on paragraph 10.4).

Pointmobile recommends that you leave the base connected to its power source at all times, so that

it is always ready to use.

12.7.

Charging the Battery

The base powers the terminal and fully charges the battery pack in 5 hours depending on the

battery.

As battery packs charge, the charging circuitry follows the two-step charging process (CC-CV) that is

recommended for Li-Ion batteries.

The process monitors changes in temperature, current, and voltage.

The battery can be inserted in the battery charging well in back of the terminal connection. Angle

the battery as shown. Once the connectors engage, the LED lights. If the LED is red, the unit is

charging; if it is green, the charge is complete

WARNING: Do not short-circuit between each contact of the cradle. It may cause fire.

AVERTISSEMENT : Provoquer un court-circuit entre les contacts de la station d’accueil, pourrait provoquer un incendie.