User's Manual

33
To perform a Hard Reset if the terminal has stopped responding, press and hold the Power button
for 8 seconds until the terminal starts to re-boot.
Factory Reset
CAUTION: To prevent data loss, back up all user data to an SD card or external memory
device before performing an upgrade or factory reset.
To Perform a Factory Reset:
1. Perform a Hard Reset
2. The terminal will reboot automatically and you will see first booting screen
3. Press “1277” when version information is displayed and then you will enter bootloader menu.
4. Press “12” to perform a factory reset.
5. When the clean boot is completed, do a touch calibration.
4.20. Suspend Mode
Suspend Mode suspends terminal operation. The terminal appears to be “off” when in Suspend
Mode. The terminal is programmed to go into Suspend Mode automatically when inactive for a
specified period of time. You can set this time period in the Power setting.
To suspend and resume operation, press the Power button. You may also press the front Scan key
to wake a suspended device unless the battery door has been removed and replaced.
☞NOTE: You should always put the terminal in Suspend Mode when you change the battery pack; see Changing the
Battery Pack on paragraph 4.18.
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Power button, the main battery might be too low
to resume operation. To check, remove the battery and install a fully charged battery or connect the
terminal to a Handy Terminal charging peripheral.
4.21. Memory Allocation
You can verify file storage and program memory in System Properties.
1. Tap Start -> Settings -> System -> Memory tab.
4.22. Care and Cleaning of the Products
When needed, clean the image engine window and the LCD display
with a clean, non-abrasive, lint-free cloth. The terminal can be
cleaned with a damp cloth.