User's Manual

56
Delay Before
Decoding(IT5300SR
device only)
Start to decoding after specified
milliseconds
Values: 0(default), 100, 200,
300, 400, 500, 4500,
700, 800, 900, 1000
Wedge mode
User Message
Select Result Type
User Message
Keyboard Event
Clipboard(default)
Terminator
Select the desired barcode end
method from the pull down list.
Values: None, CRLF, Space,
Tab
Power Save Options
(N4313 device only)
Power Save Mode
Select Power Save Mode
OFF
SLEEP
HIBERNATE(default)
Power Save TimeOut
(sec)
1~65535
Notification
Beep
If enabled
– plays audio sound
Volume
Set sounds volume.
Good read
Set sound to indicate good read.
Bad read
Set sound to indicate bad read.
LED
Enable
Enable visual scan indicators.
Vibrator
If enabled
- Turn on LED for good/bad
scan indicator
Good read
Set vibration time after
good read.
Bad read
Set vibration time after
bad read.
Wedge
Advanced settings for
string modification
Transmit Barcode ID
Enable to transmit predefined
barcode ID in Detail tab
Prefix
Enter Prefix to be sent prior to
the decoded/received data.
Suffix
Enter Suffix to be sent after the
decoded/received data
Translate
Scan Data 에서 지정한
문자(열)을 다른 문자(열)로
변경
Trim Left
Scan data 에서 지정한 길이
만큼 왼쪽에서 삭제
Trim Right
Scan data 에서 지정한 길이
만큼 오른쪽에서 삭제
Get First
Scan data 에서 지정한 길이
만큼 왼쪽에서 가져오기
Get Last
Scan data 에서 지정한 길이
만큼 오른쪽에서 가져오기
Symbologies
Select barcode types you want to read
There is “Enable All” and “Disable All” to enable/disable all symbologies