Users Manual

4. Do not use wireless chargers in severe high temperature, humidity or corrosive environments to avoid
leakage of damaged circuits.
5. Do not place too close to magnetic cards (ID cards, bank cards, etc.) with magnetic strips or chips to avoid
magnetic card failure.
6. Keep more than 20cm between the implanted medical device (pacemaker, implantable cochlea, etc.) and the
wireless charger to avoid potential disruption to medical devices.
7. Keep children from the product in case they play the wireless charger as a toy to avoid accidents.
8. Keep the wireless charger and receiver device away from water and other liquids.
9. To clean the charger, make sure the power supply is disconnected.
10. Usage temperature: 0-45℃.
11. Usage humidity: 20-85% (40℃)
* Pictures in this manual are all illustration. Final product is subject to fact.
* Inside package: alarm charger, charging cable, manual.
* power adapter is not included. Please purchase otherwise or use phone original adapter.
II. Specification
Name：UV Disinfection Lamp Clock Wireless Charger
Model: SY-W0290
Input: 5V/2.65A（MAX）, 9V/2.5A（MAX）
Output power: 5W/7.5W/10W (MAX)
Charging efficiency: 73%
Charging distance: ≤8mm
Frequency: 111.06kHz to 171.96 kHz
Size: 145x116x73mm
IV. Applicable Devices
Products qualified with Qi standard.
V. FCC warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.