Owners manual
©2016 POISON SPYDER CUSTOMS 951-849-5911 • WWW.POISONSPYDER.COM
INSTALLATION INSTRUCTIONS INST-18-06-021_A
JK Trail Corners™
IMPORTANT: Thank you for purchasing this Poison Spyder product. Please read through this entire document before proceeding with installation. If you are not
confident in your mechanical skills, please seek the help of a professional to perform the installation. Check your packages immediately upon arrival to ensure that
everything listed is included, and to check for damage during shipping. If anything is missing or damaged, or if you need technical assistance with any aspect of
this installation, call Poison Spyder at (951) 849-5911 as soon as possible. This document last updated December 2016.
APPLICATIONS
These installation instructions apply to the following
Poison Spyder products:
18-06-020P1 JK 4-Dr Trail Corners - LED Taillights - Black
18-06-021P1 JK 4-Dr Trail Corners - LED Tail & Backup Lights - Black
18-06-022P1 JK 4-Dr Trail Corners - OEM Taillights - Black
PARTS LIST
(1) Right Side JK Trail Corner
(1) Left Side JK Trail Corner
(1)* JK Trail Corner Hardware Kit
PN: HWKIT-18-06-020 includes:
(23) 1/4-20 X 1 SS Button Head Cap Screw
(23) 1/4-20 Nut-Sert
(1) 1/4” Nut-Sert Install Tool - includes:
(1) 1/4-20 X 2 Gr8 Hex Head Cap Screw
(2) 1/4” SAE Hardened Flat Washer
(1) 3/8-16 X 1-1/8 Coupling Nut
(1) 1/4-20 Nut-Sert
TOOLS NEEDED
• Phillips head & small flat head screwdrivers
• Welding clamps or C-clamps
• Measuring tape
• Drill motor, 5/16” & 25/64” drill bits
• Fine tip felt marker
• Touch-up paint or clear coat
• 5/8” open end wrench
• 5/32” hex key or driver bit
• 2-3/4” hole saw (optional, if installing 2-1/2” LED back-
up lamps)
• OPTIONAL: Professional Nut-Sert Install Tool
INSTALLATION PROCEDURE
1. Park vehicle on a level surface and set the emergency
brake. You will want to wear eye protection beyond this
point in time.
2. Begin with the driver’s side Trail Corner installation.
The procedure for both sides is nearly identical, with a few
small differences, which will be denoted in the following
steps.
3. Remove the license plate and license plate mount.
The wiring for the license plate light will need to be un-
plugged.
4. Use a Phillips screwdriver to remove the stock
taillight assembly from the Jeep. Note that there are four
screws, one in each corner of the taillight housing. You
only need to remove the two inboard screws. Once these
two screws are removed, grip the taillight assembly, slide it
slightly toward the center of the Jeep and pop it out.