Owners manual

POISON SPYDER CUSTOMS INST-18-06-021_A • JK Trail Corners™ 3

When working on the driver’s side, the Trail Corner will

slip snugly over the fuel ﬁller trim piece (and stock taillight

housing, if present), assisting with aligning it.

11. Use the 5/16” bit and drill motor to drill through

the Jeep’s outer sheetmetal at each of the hole locations in

the Trail Corner, using the Trail Corner itself as your drill

guide. If the Trail Corner shifts or the clamps loosen while

you’re drilling, stop drilling and re-align the Trail Corner

and re-clamp it, making sure it still aligns with the holes

already drilled.

12. If installing Trail Corners with holes for 2-1/2”

backup lamps, use the ﬁne-tip felt marker to mark these

holes to be cut later.

13. Un-clamp and remove the Trail Corner, then use

the 25/64” drill bit to open up each of the holes to the

larger size. Be careful when drilling, as the thin sheetmetal

may want to catch on the bit and deform it, making the

subsequent nut-sert installation more difﬁcult.

14. If installing Trail Corners with holes for 2-1/2”

backup lamps, cut these holes now at the locations that

were marked in Step 9. A 2-3/4” hole saw works best

for this.

15. Install a 1/4-20 nut-sert into each of the holes that

were drilled out to 25/64”.

NOTE: It is HIGHLY RECOMMENDED to invest in

a professional nut-sert installation tool, such as the

one sold by Poison Spyder (p/n: 70-TS-325-RN ) or

elsewhere.

The professional tool will make the installation of nut-

serts MUCH easier than using the free tool included

in this kit, and it will come in handy with future product

installations as well. If using a professional nut-

sert installation tool, follow the directions that came

with the tool and skip the next three steps of these

instructions. The simple “tool” included with this

product is admittedly frustrating to use, however it will

work for those with patience who would like to save

the cost of the professional tool. If using the simple

tool included with this product, continue through the

following steps:

16. The provided nut-sert install tool consists of a bolt,

two washers and a coupler (long) nut. Assemble these

items as shown (bolt—washer—coupler nut—washer—

nut-sert). Insert the nut-sert end of the assembly into the

hole you drilled.