Owners manual

ManualsBrandsPoison Spyder ManualsAutomotive41-06-030 LED Back-Up Light Extension Harness Fits Wrangler (JK)

INSTALLATION INSTRUCTIONS

41-06-010-P • JK LED Taillight Harness - Passenger Side

41-06-010-D • JK LED Taillight Harness - Driver Side

41-06-020 • 24in LED Back-Up Light Extension Harness (Pair)

41-06-030 • 4in LED Back-Up Light Extension Harness (Pair)

Thank you for purchasing Poison Spyder’s JK

LED Taillight Harness system. Depending on

the components you chose, you may not have all

of the items shown in the photos above. Simply

disregard the instructions for any components

you are not using in your own installation.

Installation is fairly simple with the right tools

and good mechanical abilities. If you are not

condent in your mechanical skills, please

seek the help of a professional to perform the

installation. Please read through these entire

instructions before proceeding with installation.

Please check your packages immediately upon

arrival to ensure that everything you ordered

is included, and to check for damage during

shipping. If anything is missing or damaged,

call Poison Spyder at (951) 849-5911 as soon

as possible.

TOOLS NEEDED

• Phillipsscrewdriver

• Zip-ties

• Sheetmetalscrews&drillwithdriverbit

NOTE: Installation assumes the use of 4” round

LED taillights and 2-1/2” round LED back-up

lights sold by Poison Spyder Customs. Other

manufacturers’ lighting products may also be

compatible, however they are not guaranteed to

work with this harness.

INSTALLATION PROCEDURE

1. Park vehicle on a level surface,placethe

transmission in gear or park, and set the

emergencybrake.Wearsafetyglassesfrom

thispointon.

2. Beginning on the passenger side, use

a Phillips screwdriver to remove the stock

taillightassembly fromthe Jeep. Notethat

there are four screws, one in each corner

of the taillight housing.  You only need to

removethetwoinboardscrews.Oncethese

two screws are removed, grip the taillight

assembly, slide it slightly toward the center

oftheJeepandpopitout.

JK LED TAILLIGHT HARNESS INSTALLATION

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS JK LED TAILLIGHT HARNESS INSTALLATION installation. Please read through these entire instructions before proceeding with installation. Please check your packages immediately upon arrival to ensure that everything you ordered is included, and to check for damage during shipping. If anything is missing or damaged, call Poison Spyder at (951) 849-5911 as soon as possible.
PAGE 2
FIGURE 1 3. With your thumb, press on the release tab of the taillight harness plug, and separate it from the vehicle harness. Set the OE taillight assembly aside. FIGURE 19 5. Secure the gold anodized resistor heat sink into place inside the Jeep’s corner cavity. This may be done by using a couple of small self-tapping sheet metal screws and a long driver extension for your drill, to secure it to the flat surface inside the cavity.
PAGE 3
described in the previous step. For backup lights mounted below or next to the LED taillight, use the short 4” extension harness. If no backup lights are used, simply leave the plastic plugs in place on the harness. 8. Use zip-ties or other means to secure all wiring in place, both inside the Jeep’s corner cavity and wherever extension wires have been routed. 9.
PAGE 4
WARRANTY Poison Spyder Customs™ warranties all of the products we sell and distribute for one (1) year from the date of sale. These products will be free from defects in material and workmanship under normal installation, and use. Due to the intended use the powder coat finish is warranted for ninety (90) days. The finish warranty will not cover a product if it has been damaged in any way. Warranty is limited to repair or replacement.