Manual
INSTALLATION INSTRUCTIONS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
be easier to use nut-serts at the forward-most
hardware locations on either side as well, so
we have provided 2 additional nut-serts for this
purpose, in the hardware kits for those vehicles.
10. If installing Comp-Cut corners, use a
pneumatic body saw or other suitable tool
tocutalongthepreviously-markedcutlines.
De-bur the cut edges with a grinder or le.
It is recommended to spray an aerosol clear
coat over the areas where exposed metal
shows through. Comp Cut corners require
therelocationofthetailgatehingesonTJ’s
and YJ’s as well as the relocation the rear
body mount on all vehicles
11. If installing the LED taillights, cut out the
hole using a 4.5” hole saw or pneumatic
bodysaw.Besuretocheckforwiringbehind
the sheet metal prior to cutting. On CJ8’s
withLED’sthehorizontalportionoftheinner
wheelwellwillneedtobetrimmed.Spray
the exposed cut edges with clear-coat to
preventrust.
12. Using the supplied hardware, re-install the
Crusher Corner into place. Loosely install
atheadcapscrew,atwasher(ontheback
side)andlocknut.Donottightenhardware
at this time (allow the Crusher Corner to
“oat”untilallhardwareislooselyinstalled).
Onceallhardwareisinplace,carefullyalign
the Crusher Corner into place, then tighten
all hardware using the 7/32 hex key and 9/16
wrench.
13. If installing LED taillights, continue
with Poison Spyder’s separate instruction
sheet “LED TAILLIGHTS & FLASHERS
INSTALLATION”, which came with your
LED taillights (if purchased through Poison
Spyder) or may be downloaded in PDF form
fromtheTechLibrarysectionofourwebsite.
13. Re install any OE pieces that will re reused
(ares,gasllerbezel,licenseplatebracket
orOEtaillights).
Poison Spyder Customs • CRUSHER CORNERS INSTALLATION Page 3