User Manual

INSTALLATION INSTRUCTIONS
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
Poison Spyder Customs • JKBRAWLERMIDFRONTBUMPER Page2
3. If your Jeep is equipped with factory
fog lamps, reach behind the bumper and
disconnectthewiringharnessplugsfromthe
socketsatthebackofeachlamp.Asmallat
head screwdriver may be useful to release
thetangsontheplug
4. Use a ratchet and 19mm deep socket to
remove the eight (8) nuts that fasten the
bumpertotheframe.Therearetwoofthese
nutsontheinnerside,andtwoontheouter
side, of each frame rail where it joins the
bumper.
FIGURE 3
With these nuts removed, remove the
bumperfromtheJeep.
FIGURE 4
5. If your Jeep is equipped with factory fog
lamps,thesemayberemovedfromthestock
bumper and re-installed into the Brawler
MIDbumper.  Use a Phillipsscrewdriver to
remove the four (4) retaining screws from
eachlamp,onthebacksideofthebumper.
FIGURE 5
Installthefactoryfoglampsintothefoglamp
mountsinthebacksideoftheBrawlerMID
bumper.  Re-use the OE retaining screws.
Thesesheetmetalscrewswillformtheirown
threadsasyoudrivethemintotheretaining
ringsontheRockBrawlerbumper,sopress
rmlyasyoutwistthescrewdriver.
FIGURE 6
6. Remove the plastic top bumper cover.
You may be able to remove thetwo plastic
screwswithaPhillipsscrewdriver.Butitis
likelythey’re“frozen”inplaceandwillhaveto
bepriedupwiththepush-inretainerremoval
tool.
FIGURE 7