Instruction Manual

INSTALLATION INSTRUCTIONS
Poison Spyder Customs • JK FRONT ROCKBRAWLER BUMPER INSTALL Page 2
©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
yourself, we recommend starting with a quality
etching primer and allowing sufcient cure/dry
time between coats and before you apply color.
Quality spray-can paints are ne, however be
sure to thoroughly paint all of the inside corners
and hard-to-reach areas of the bumper. A
little extra time and attention to detail on your
preparation and paint process will pay off in
longer-lasting good looks and rust prevention.
INSTALLATION PROCEDURE
1. Parkvehicleonalevelsurfaceandsetthe
emergencybrake.Youwillwanttoweareye
protectionbeyondthispoint.
2. Removetheplasticlowerairdam.Usea
push-inretainerremovaltooltopopoutthe
plasticpush-inretainersalongthefrontedge
and also underneath/behind the air dam
whereitattachestothecrashbar.Ifyoudo
nothaveapush-inretainertool,aat-edge
screwdriverorsmallpry-barmaybeused.
FIGURE 2
3. If your Jeep is equipped with factory
fog lamps, reach behind the bumper and
disconnectthewiringharnessplugsfromthe
socketsatthebackofeachlamp.Asmallat
head screwdriver may be useful to release
thetangsontheplug
4. Use a ratchet and 19mm deep socket to
remove the eight (8) nuts that fasten the
bumpertotheframe.Therearetwoofthese
nutsontheinnerside,andtwoontheouter
side, of each frame rail where it joins the
bumper.
FIGURE 3
With these nuts removed, remove the
bumperfromtheJeep.
FIGURE 4
5. If your Jeep is equipped with factory fog
lamps,thesemayberemovedfromthestock
bumperandre-installedintotheRockBrawler
bumper.UseaPhillipsscrewdrivertoremove
thefour(4)retainingscrewsfromeachlamp,
onthebacksideofthebumper.
FIGURE 5
Installthefactoryfoglampsintothefoglamp
mountsinthebacksideoftheRockBrawler
bumper.  Re-use the OE retaining screws.
Thesesheetmetalscrewswillformtheirown
threadsasyoudrivethemintotheretaining