Instruction Manual

INSTALLATION INSTRUCTIONS

Poison Spyder Customs •

JK FRONT ROCKBRAWLER BUMPER INSTALL

Page 4

not properly seat into position yet.  Do not

installtheinboardnutsatthistime.

FIGURE 10

9. Observe the recessed area where the

removableskidplateistobeinstalledalong

the front lower surface of the RockBrawler

bumper.  The lower-most hole in this

recessed surface, on each side, is backed

by a weld-nut which interferes with the OE

crash bar that is located directly behind it.

Later,youwilldrillholesinthecrashbarto

provideclearance fortheseweld nuts.But

rst,useahammerand5/16”transferpunch

inserted through this hole (and weld-nut)

to make a corresponding drill mark on the

surfaceofthecrashbar(seeFigure11).Do

thisforthelower-mostholeonbothendsof

therecessedskidplatemountingsurface.

FIGURE 11

10.Loosen the four previously installed

bumpermountinglocknutsandatwashers,

and remove the RockBrawler bumper from

theJeep.

11.Useadrillmotorwith1/4”bittodrillthrough

the front surface of the crash bar at both

locationsyoumarkedwiththetransferpunch

inStep9.Switchtothe11/16”bittodrilleach

holetoitsnalsize.

FIGURE 12

De-burr the edges of the holes then apply

touch-uppaintorclearcoatto theexposed

metal.

12.If your Jeep is equipped with the factory

electric sway bar disconnect or the Currie

Anti-Rockswaybarsystem,pre-positionthe

sub-framebracketasshowninFigure12.

FIGURE 13

Useacoupleofzip-tiestotemporarilyholdit

inplaceagainstthecrashbar.

FIGURE 14

IfyourJeepisNOTequippedwiththefactory

electricsway bar disconnector CurrieAnti-

Rock,youmayskipthisstepasyouwillbe