Instruction Manual

INSTALLATION INSTRUCTIONS
Poison Spyder Customs • JK FRONT ROCKBRAWLER BUMPER INSTALL Page 5
©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
abletoinstallthebracketlaterwithouthaving
pre-positionedit.
13.Re-install the RockBrawler bumper onto
theJeep.Itshouldfullyseatthistime,with
the weld-nuts mentioned in Step 9 tting
through the clearance holes you drilled.
Installandtightenalleight(8)locknutsand
atwashersontothebumpermountingstuds
(twoinboardandtwooutboardofeachframe
rail).
14.Ifyou installed the OE foglamps into the
RockBrawler bumper, plug the harness
connectorsbackintothesocketsintheback
of each lamp.  Use the OE wire harness
push-inretainerstosecuretheharnesstothe
three (3) provided holes on a ange inside
theRockBrawlerbumper. These holes are
showninFigure15,withthebumperoffthe
Jeepforclarity.Youwillhavetolocatethem
byfeelastheareaishardtoseeoncethe
bumperisinstalled.
FIGURE 15
15.Pre-position the Sub-Frame Bracket
Retainer Plate.  There are three slotted
holesintheverticalangeatthetop/rearof
thebumper.Insertthethreecapturedstuds
on the retainer plate through these slots,
from the inner side of the bumper (so that
thethreadsarepointedtowardtherearofthe
Jeep).  Figure 16 illustrates this on an un-
installedbumperforclarity.
FIGURE 16
16.InstalltheSub-FrameBracket,whichyou
mayhavealreadypre-positionedinStep12
(cuttheziptiesifyoudid).Thethreeslotted
holesalongthetopofthebracketaretobe
slipped over the three protruding threaded
studs of the Sub-Frame Bracket Retainer
Plate (which was pre-positioned in the
precedingstep).TheloweredgeoftheSub-
Frame Bracket will t against the backside
andundersideofthecrashbar.Wherethe
90° ange ts against the underside of the
crash bar, it will t between the crash bar
andthelowerlipofthebumperateitherend.
Installa1/2-20locknutand1/2”atwasher
ontoeachofthethree(3)threadedstudsof
the Sub-Frame Bracket Retainer Plate, but
donottightenthematthistime.
17.Pre-InstalltheRemovableSkidPlate.Use
three 3/at head cap screws to temporarily
holditinplace,oneatthecenteralongthe
topand onealongthe bottomateach end.
Ensurethattheskidplateisproperlyseated
intoits recessinthe bumper,andsnugthe
threeatheadcapscrews.
FIGURE 17
18.The ve countersunk holes along the
bottom edge of the skid plate will require